MFD is the factory-backed production partner for interior designers, architects, and design consultants who already have a finalized concept and need bespoke joinery fabricated, finished, and installed without delay or guesswork.
A few millimetres missed on site shows up as a visible gap, a misaligned panel, or a unit that doesn’t sit flush against the wall.
Veneer grain, lacquer sheen, or hardware tone that drifts from the specification puts your name on a result you didn’t approve.
Joinery that isn’t sequenced with electrical, MEP, or flooring causes on-site rework and pushes your handover date.
A workshop without real factory capacity slips on timelines the moment a project gets complex, and that delay lands on you, not them.
None of this is a design problem. It’s a production problem. MFD exists to remove it — running fabrication from your drawings, in our own factory, with the tolerances and finish control a client-facing handover demands.
Units built to the drawing, not approximated on-site.
Material, sheen, and hardware delivered as approved — no surprises at install.
Production timelines confirmed up front and held through fabrication.
Clean site delivery and fitting, coordinated around your project’s sequence.
MFD executes bespoke joinery and millwork from finalized drawings. We do not originate design concepts — we turn them into precise, factory-built reality.
Fitted wardrobes, kitchens, vanity units, and built-in storage fabricated to drawing-exact dimensions and hardware specification.
Reception desks, feature counters, and front-of-house joinery built for repeatable finish quality across multi-unit or hospitality fit-outs.
Material sourcing, veneer matching, lacquer finishing, and metal inlay work executed to match your approved sample board.
Architectural wall cladding and ceiling panel systems fabricated off-site for clean, low-disruption on-site fitting.
CNC-supported batch fabrication for projects requiring consistent output across multiple rooms, units, or floors.
Site-ready delivery and fitting sequenced around your project timeline, MEP coordination, and handover date.
Five stages. No design revisions in between — just the coordination required to fabricate your scope correctly and deliver it on schedule.
Your approved drawings and specification are reviewed for production feasibility and material requirements.
A confirmed fabrication scope, material list, and timeline are issued before any cutting begins.
Units are cut, assembled, and finished in-house under fixed tolerance and finish standards.
Every unit is checked against the drawing and sample before it leaves the factory floor.
Delivery and fitting coordinated with your site schedule, trades, and handover date.
Representative examples of the type of drawing-based production MFD executes. Specific project references and finish samples are shared during the production review.
Project imagery, finish samples, and references available on request during the production review.
Pricing follows a production review of your drawings, materials, and finish specification — not a flat rate quoted blind.
We confirm a fabrication timeline before work begins, so your handover date is planned around, not threatened by it.
Material, veneer, and finish are checked against your sample board before fabrication and again before dispatch.
Yes. We coordinate fabrication and install timing directly with your project lead, site team, or other trades as required.
Send your approved drawings, finish specification, and timeline. We’ll review production feasibility and respond with a clear scope and next step — not a sales call.
Share your drawings, finish specification, and timeline. We’ll review feasibility and respond with a clear production scope — no design discovery, no months of waiting.
